Daily Maintenance Of Inkjet Printer

The nozzle is one of the important parts of the inkjet printer and also one of the most delicate parts. The use of the nozzle focuses on maintenance and care. The quality of maintenance and care directly determines the use effect and service life of the nozzle. How to make your equipment bring greater profits. Extending the working life of the nozzle is one of the means to reduce costs. The following are the methods to extend the service life of the nozzle:
Environment
If the working environment of the indoor equipment is not very good, dust can easily enter the main ink cartridge and then the auxiliary ink cartridge, and then enter the nozzle, affecting the printing effect of the nozzle and shortening the service life of the nozzle.
Operation
The nozzle part of the nozzle surface cannot be rubbed with any object, and fine hair is easy to hang on the nozzle surface. Cause clogging and ink dripping, thereby affecting the inkjet effect. Therefore, it is also very important to operate the equipment strictly in accordance with the requirements.
Auxiliary accessories
Every accessory on the machine has its purpose, do not remove it at will. Like the main ink cartridge, auxiliary ink cartridge, filter, etc.
Ink
The quality of the ink directly affects the quality of the picture and the nozzle. It is best to use the ink recommended by the equipment manufacturer, because these inks have been strictly and long-term tested, and there is a certain guarantee for the equipment and the nozzle. Do not add anything to the ink at will.
Maintenance
Before shutting down and powering off the printer, the nozzle must be cleaned and placed on a nozzle cover with a moisturizing sponge pad. This can ensure the nozzle condition and inkjet quality, and also extend the nozzle life to a certain extent.
Nozzle maintenance
The nozzle is the most fragile and core component in the printer, so the nozzle must be handled with care to avoid damaging the above components. The aperture of the nozzle plate of the printer is between 45 microns and 72 microns, and the inner diameter of the recovery hole is about 2 mm. These two components must be cleaned separately before shutting down.